breakwaters seawalls and groins are all examples of

#BREAKWATERS SEAWALLS AND GROINS ARE ALL EXAMPLES OF SERIES#

The sudden release of wave energy on a seawall can create turbulence, which undermines the sediment at the base of the wall and causes it to erode. However, as with the other forms of hard stabilization we have discussed, seawalls are not without their own environmental consequences. They are often utilized in beachfront property to prevent the ground under a home from being undermined by the waves. The walls are designed as a barrier between the waves and the shore, to prevent the land from being eroded (Figure 13.5.4). Seawalls are constructed at the top of the surf zone, where the waves crash against the shore. Right Santa Monica Pier in 2011 (© JCS, CC BY-SA 3.0, via Wikimedia Commons). Left aerial image of Santa Monica Pier and breakwater from 1936 (Courtesy of Santa Monica Public Library Image Archives/ Spence Air Photos). Now that the breakwater is no longer in place, the bulge in the shoreline is gone, and the beach is much straighter once again ( below right). Following the construction, the once-straight beach became much wider behind the breakwater as sand accumulated in the absence of strong wave action ( below left). A breakwater was constructed in the early 1930s to protect the pier and the boats that moored near it.

The beach around the Santa Monica Pier in California provides a good example of the effects of breakwaters on a sandy shore. In this case, sand has accumulated to the point that they now connect the breakwaters to land (Google Maps Imagery: DigitalGlobe, Aerodata,International Surveys, TerraMetrics, Data SIO, NOAA, US Navy, NGA, GEBCO, Map Data: Google).

#BREAKWATERS SEAWALLS AND GROINS ARE ALL EXAMPLES OF SERIES#

With the longshore transport interrupted, increased erosion can occur downstream of the breakwater.įigure 13.5.3 A series of breakwaters along the coast in Skagen, Denmark. The beach grows behind a breakwater, until eventually they may become connected (Figure 13.5.3).

Longshore transport continues to move sand along the beach, but once it gets behind the breakwater the lack of wave action interrupts the flow, and the sand settles and accumulates. But breakwaters do have an unintended impact on sediment distribution. Their purpose is not necessarily to interfere with sediment transport, but instead to protect the areas behind them from heavy wave action, so they are often deployed at the mouth of a harbor, or to protect the boats in a mooring field. Sand has accumulated on the left (north) side of the harbor, and the beach is eroded on the right (south) side (Google Maps, Map Data: Google).īreakwaters are walls that are usually built parallel to the shore. If too much sand accumulates upstream of the jetty it can spread past the jetty and into the mouth of the harbor, in which case the jetty may need to be extended.įigure 13.5.2 The jetties protecting Santa Cruz harbor, California. Because they are longer they can trap more sand than groins, and they also can contribute to increased erosion on the downstream side (Figure 13.5.2). Jetties are like longer groins, often built to protect the mouths of harbors to prevent them from filling with sand. Longshore transport would move from the bottom of the picture towards the top (, Public Domain, CC0).

Longshore transport would be moving from right to left, accumulating sand on the right of the groin (Beatrice Murch,, CC BY-SA 2.0). Eventually a beach may become covered in a series of groins, called a groin field, all trying to stabilize the natural flow of sand (Figure 13.5.1 right).įigure 13.5.1 Left: A groin on Bolinas Beach, California. To prevent that erosion, another groin must be built downstream of the first one, which then creates its own erosion problems, leading to another groin, and so on. But downstream of the groin the source of replacement sand is cut off, while sand continues to be removed, so erosion can become even more pronounced on that side of the groin. Groins are built to interrupt longshore transport and trap sand upstream of the groin, which they do very well. Groins (or groynes) are barriers built perpendicular to the shore (Figure 13.5.1 left). While some of these efforts have been successful, many others have actually exacerbated the problem, as we will see below. So from our perspective, we often see the transient nature of the coast as a threat to our activities, and as a result we have developed a number of ways to try and influence the erosion process, usually through hard stabilization, or the building of structures to stop the flow of sand. However, we have also come to enjoy and rely on many of these beaches and other coastal features for commerce, recreation, and living space. The continued erosion and deposition of coastal sediments is a natural process, with features forming and disappearing as sea level and other conditions change.

Breakwaters seawalls and groins are all examples of